Endless hot water on a wall-mounted unit. Here's what it takes to install one.
Tankless water heater installation mounts a wall-mounted gas unit that heats water as it flows, then connects the gas, water, venting and condensate drain. In Thornhill the gas line often has to be upsized, because a tankless unit uses more gas than a tank.
This page covers gas line size, venting, the condensate drain, what changes when you replace a tank and how the install goes.
Often not. A tankless unit draws a lot of gas at once, and it's often fed by a larger line than a tank needs. The line also has to carry every other appliance on it, not just the heater. We check the load, upsize the line if needed and pressure test it.
Tankless units usually vent through a wall in plastic pipe. They generally can't share a vent with other appliances, and the vent has to be the kind listed for that exact unit.
Fill out the form, or call and we'll book it with you.
High-efficiency units make acidic water. It needs a drain, usually a neutralizer, and a pump if there's no floor drain close by.
No. Going from a tank to tankless changes the gas line, the vent and the drain. We plan the vent and drain route before we start, and we tell you which permits apply.
Water connections
Isolation valves, so the unit can be flushed later
Our Thornhill location is 7163 Yonge St, Unit 260, Markham, ON L3T 0C8. Call (437) 410-8394 and we'll book your visit.
Call (437) 410-8394We answer 24 hours a day, 7 days a week.