Smell gas? Leave now, then call Enbridge at 1-866-763-5427 or 911 from a safe place.
HOME HEATING

Furnace Repair in Thornhill

No heat? Start with the checks below, then call us for the repair.

Furnace repair finds why a gas furnace isn't heating, whether that's the ignitor, the flame sensor, the blower, a clogged filter, a blocked vent or the thermostat, and replaces the failed part. In Thornhill, gas furnaces fall under TSSA rules, and Thorn Hill Gas Line Repair is licensed and insured.

This page covers what to check first, common causes, why a furnace turns on and off, and when to repair or replace.

Why is my furnace not heating?

Is it the ignitor or the flame sensor?

They're among the most common parts to fail, because they work every time the furnace starts. A weak ignitor means the burners don't light. A dirty flame sensor makes the burners light and then shut off after a few seconds.

Book an in-home quote

Fill out the form, or call and we'll book it with you.

Why does my furnace keep turning on and off?

That's called short cycling. Common causes are a dirty filter, restricted airflow that makes the furnace overheat, a bad limit switch, a thermostat fault and a furnace that's too big for the house. It also wears out the blower and the ignition parts, so don't leave it.

What if there's a cracked heat exchanger?

A crack in the heat exchanger can let combustion gases, including carbon monoxide, into the air you breathe. Signs include soot, a burning smell, a yellow flame, or a carbon monoxide alarm. Turn the furnace off and call us. A cracked heat exchanger is a safety problem, and the fix is often replacement.

What can I check before calling?

Check the thermostat is on heat, the filter is clean and the switch near the furnace is on. If you smell gas, leave and call Enbridge at 1-866-763-5427 first.

Repair or replace?

A furnace past its expected life with a large repair is often better replaced. We'll compare both numbers for you.

Red tag on your furnace?

See our red tag repair page.

No heat on the first cold morning?

The first start-up of the season is when a worn ignitor, a dirty flame sensor or a blocked filter shows itself. Before you call:

  1. Confirm the thermostat is on heat and set above room temperature.
  2. Check the filter, and replace it if it's clogged.
  3. Check the switch near the furnace is on.
  4. Look at the furnace's blinking light or error code, if it has one, and tell us what it shows.
  5. If you smell gas, leave and call Enbridge first.
Talk to a technician: (437) 410-8394Request a quote

Related services in Thornhill

WE'RE CLOSER THAN YOU THINK

Local to Thornhill

Our Thornhill location is 7163 Yonge St, Unit 260, Markham, ON L3T 0C8. Call (437) 410-8394 and we'll book your visit.

Book a visit

Call (437) 410-8394We answer 24 hours a day, 7 days a week.

Call (437) 410-8394